FIRST machinerybased on their own strengths, with a more powerful force, a broader
perspective, more effective measures, more effective way, leading
entrepreneurs to launch a new round of wealth storm, FIRST will
create a more glorious era, hand in hand Hengtong, you will last a
Centrifugal oil filter cleaning steps:
A centrifugal oil filter off, disconnect the power.
2 Remove the oil drain plugs pollutant room, and then connect the
oil pan with oil until the oil flow have been exhausted (you can
press the gas when you put the oil drain plug and accelerate out of
the oil), and then re-tighten the input connector block cover.
3 Remove the centrifuge input connector, centrifuge output
connector, remove the protective cover centrifuge, remove the belt,
while 16 with a wrench unscrew the four screws on the base of the
centrifuge, the centrifuge from the body the removed oil pan in
4 Remove the bleed plug centrifugal oil filter, and then loaded on
the location-specific removal tools, fittings screwed onto the
cover, twist 3-4 laps, tighten the nut on the bolt to the roots,
while the bolts to the pressure plate, screwed in the end.
5 rotating nut, so that the centrifuge housing sink in the end.
Obtained at the end face of the cover 6 is pressed by the small
groove in the downward projection of the collar, then removed from
the housing in the groove of the collar.
Separate loosen nuts and bolts out, then screwed onto the pipe
joints pressure plate, screwed in the end, so that the cover and
the contact position. Remove the cover and then manually manually.
7 with a brush to remove surface deposits within the housing, and
then wipe clean with a rag to cover.
8 Remove the pressure plate, remove the titanium core portfolio,
into the oil pan, use gasoline or kerosene soaked 20 minutes after
cleaning and blowing with an air gun.
9 using pressure plate, titanium core portfolio soak time to remove
dirt holding chamber front panel, with a rag to wipe dirt holding
room and then re-installed (installed seals to prevent
10 with gasoline or kerosene to flush out the dirt inside the
impeller, and blowing with an air gun.
? 11 in reverse order to the centrifugal oil filter assembly up and
collar when installed, the pipe fitting screwed into the plug hole
position, rotation, three to four laps, then bolt screwed into the
pressure plate, tighten the nut until the pressure in the end cover
until the finally mounted on the collar.
12 Loosen the nuts and bolts and fittings unscrew the screw on the
13 re centrifugal oil filter onto the body, tighten the nut, then
the input port and an output port connector joints tightened to the
centrifugal oil filter base connector.
14 Plug in the power cord, turn on the power switch, start the gear
pump, the system is filled with oil, and rotating valve, regulating
the pressure of 0.1 ~ 0.2MPa, check if the seal piping and all
local oil spill (if any oil spill , reinstall). Close gear pump,
disconnect the power, unplug the power cord.
15 open belt installation window, belts installed, and then
re-install the belt cover mounted on the window.
Finally, the centrifugal oil filter cover equipment, centrifuges
cover nylon cover cover.
16 next startup, operation in accordance with operating
17 cleaned once every 10 hours to run. More Consulting Welcome